Zero-D Products, Inc.
precision engineered materials solutions

Manufacturer of the most dependable and consistent mold rubbers available today.

   

SpinKast™ Silicones

Available in all popular sizes

22.8 cm (9 inch) set of 4 disks 10 sets per box

30.5 cm (12 inch) set of 4 disks 10 sets per box

38.1 cm (15 inch) set of 4 disks 5 sets per box

45.7 cm (18 inch) set of 4 disks 5 sets per box

50.8 cm (20 inch) set of 4 disks 5 sets per box

All disks are 6.35mm (1/4 inch) thick 4 disks per set

We will also make other hardness' grades and colors by special order.


SpinKast Standard™

For pewter and other low melt alloys and plastics. High tear strength with excellent elongation properties. Great for under-cuts.

Cure: 350°F (177°C)

Hardness: 55° Shore A


SpinKast ZeroShrink™ ENERGY SAVER

General purpose grade suited to any application where shrink is an important consideration. ZeroShrink™ is lower in durometer, but greater density permitting higher clamp pressure and resistance to internal deflection.

Cure: from 160°F (71°C) through 250°F (121°C)

Hardness: 45° Shore A


SpinKast LT™ ENERGY SAVER

Low temperature cure for pewter and other low temperature metals and plastics. Excellent for models made from temperature sensitive materials.

Cure: from 160°F (71°C) through 250°F (121°C)

Hardness: 55° Shore A


SpinKast Sparkle HT 55™

Zinc, Pewter and other low temperature materials. Special formulation permits very rapid heat transfer outward.

Very rapid cooling of the casting permits much shorter cycle times and fewer molds per run.

Cure: 350°F (177°C) Also available in low temp cure

Hardness: 55° Shore A