4X QUICK-CURE Silicone Mold Rubber is an economical, medium to firm rubber with extremely high tear strength and very rapid cure. It is intended to be used for all applications. Detail replication is excellent.

You can have a mold ready to inject in 30 minutes if you pre-heat your vulcanizer.

1)  Pre-heat your vulcanizer to 350°F (177°C)
2)  Using scissors, cut enough rubber to fill the mold frame to about 1/2 to 2/3 full.
3)  Push model into rubber to proper position and then cover over with  additional rubber. Work into place, being sure to over pack slightly.
4)  Place mold frame in vulcanizer, pre-heated to  350ºF (177ºC).
5)  Vulcanize 7 minutes per 1/4" (6.35mm) of thickness. A 1/2"  frame requires  14 minutes.
6)  Rapid cool in water and cut.

Release agent is not required.
Shrink rate is 1.8% (rubber only)