MATERIAL SAFETY DATA SHEET

In compliance with OSHA 29 CFR 1910.1200 and WHMIS

 

IDENTITY:     FLEX, FIRM & Low Shrink Gray grades AKRON JEWELRY RUBBER

 

 

SECTION   I      Product information

 

Manufactured and sold by:                  Emergency Telephone:  440-417-1843               

Zero -D Products Inc.                         Date Prepared:  February 3, 2011                            

7183 Lake Road East

Madison, OH 44057                             Product Usage:  Wax Casting   

 

 

SECTION II     Hazardous Ingredients Identity

 

Hazardous Components                                    Exposure Limits                                 Toxicity               Amount

Chemical Identity/CAS#/UN#                        PEL   TLV   OTHER                            LD50/LC50               %

 

The specific chemical identity of the ingredients of this rubber formulation is considered a trade secret. Details will be made available to qualified medical personnel in the event of an emergency situation.

 

Non-hazardous ingredients include typical inorganic fillers bound in a natural rubber matrix.

 

Under normal intended usage,  no hazards should exist.

 

 

SECTION  III    Physical/Chemical Characteristics

 

Boiling Point:     NA                                          Specific gravity (H2O=1):        1.35

Freezing Point:    NA                                        pH:                                              NA

Vapor Pressure (mm Hg):  NA                           Odor Threshold (ppm):            NA

Vapor Density (air = 1):  NA                             Evaporation Rate:                     NA

Solubility in Water:   Insoluble                           Melting Point:                             NA

Appearance (physical state) and Odor: rubbery solid, .125 thick, characteristic rubber odor.

 

 SECTION  IV   Fire and Explosion Hazard

 

Flash Point (method): NA                        Auto-ignition Temperature:   NA

Sensitivity to Mechanical Impact:  NA      Sensitivity / Static Discharge: NA       

Unusual Fire/Explosion Hazard: None known Hazardous Combustion Products:     NA                  

        

Flammability Limits in Air:  Lower: not determined; Upper: not determined.                                                        

Special Firefighting Procedures:

                        Self contained breathing apparatus is required for all firefighting personnel. In enclosed or poorly ventilated areas,  wear SCBA during cleanup immediately after fire. Use high expansion foam or water fog. Treat as a hydrocarbon fire.

 

 

SECTION   V   Reactivity Data

 

Stability:      Stable: yes     Unstable:  no

Conditions to Avoid:   None Known

Incompatibility (Materials to Avoid):   None Known

Hazardous Decomposition Products:    CO,  CO2,   N Oxides,   S Oxides

Hazardous Polymerization:   Will not Occur

 

SECTION    VI   Health Hazard Data

 

Threshold Limit Value:   See Section II

Primary Routes of Exposure:    Inhalation,   Skin,    Eye

Effects of Overexposure:  Containment in a polymeric binder/matrix greatly reduces the risk of contact with hazardous materials.

Health Hazards:        Acute: None Known           Chronic:   None Known

 

SECTION    VII    First Aid Measures

 

Emergency First Aid Procedures:  Flush eyes/skin with water. Consult a physician if irritation persists. If inhaled, remove to fresh air. If ingested, consult a physician.

Medical Conditions which may be Aggravated by Exposure: Individuals with chronic respiratory disorders (i.e.: asthma, chronic bronchitis, emphysema, etc.) may be adversely affected by any fume or airborne particulate exposure.  Sensitive individuals may be susceptible to allergic reaction upon contact with skin, eyes, or respiratory tract.

 

SECTION    VIII    Precautions for Safe Handling and Use

 

Steps to Take in Case of Spill:  Sweep or vacuum, collect and place in suitable container for reuse or disposal.

Waste Disposal Methods:  Follow  state, local and federal regulations.

Precautions in Handling and Storage: Keep clean in closed container. Store at room temperature and away from direct sunlight and sources of heat.

Always Wash Thoroughly with Soap and Water after use.

 

SECTION    IX    Special Protection Information

 

Respiratory Protection:  Approved NIOSH organic respirator recommended if ventilation is inadequate.

Ventilation:   Local Exhaust:   yes           Mechanical (general):     yes

 

SECTION   X    Other Compliance Information

 

Section 313 of title III of the superfund amendment and the reauthorization act of 1986 and 40 CFR part 372 requires the listing of chemicals in this compound which are subject to their reporting requirements. This information must be included in all MSDS sheets that are copied and distributed for this material. The chemicals found in this compound are:

Compound Name:       Zinc Oxide            CAS#:  1314-13-2              Percent by Weight:    2.56

 

As conditions or methods of use are beyond our control, we do not assume any responsibility and expressly disclaim any liability for any use of this material.

The information and recommendations herein contained are based upon data, which to the best of our knowledge and belief,  is accurate and reliable. With respect to the information and recommendations contained herein,  Zero-D Products makes no representations or warranties of any kind, expressed or implied.

last revised: 4-4-11